Connect the machine to the power supply and turn on the main power.

Set the thread spool. The thread end should come from the bottom front of the spool.
The spool cap closest to the thread spool size should be used to hold the spool securely on the spool post.

* The spool cap should be pushed on as far as it will go.

Guide the thread through the machine and the bobbin winding guide as marked with the dotted line.

Guide the thread through the small hole in the side of the bobbin from the inside.
Holding the thread end, push the bobbin winder shaft to right.

* Match the groove of the bobbin with the spring on the shaft.

Holding the thread end, press the "START/STOP" button.
Wind the thread a few times around the bobbin and press the "START/STOP" button again.
Trim the excess thread from the top of the bobbin after the machine stops.

* It is important to trim the thread close to the spoolend.

Press the "START/STOP" button.
The machine will stop automatically when the bobbin is full.
Press the "START/STOP" button to stop at any time or when the bobbin has stopped moving and the motor is still running.

Push the bobbin shaft to the left.
Remove the bobbin and continue sewing.