CE1010
FAQs & Troubleshooting |
CE1010
Date: 07/31/2020 ID: faqh00000095_020
How do I clean the race?
Sewing performance will suffer if lint and dust collects in the bobbin case, therefore, it should be cleaned regularly.
- Make sure you unplug the machine before you clean it. Otherwise, you may get an electric shock or be injured.
-
Turn off the machine and unplug the power cord.
-
Raise the needle and remove the presser foot.
-
Remove the needle and the presser foot holder.
(1) Screwdriver -
Loosen the two screws and remove the needle plate.
(1) Screwdriver - Be careful not to drop the removed screws in the machine.
-
Remove the bobbin case, and remove any dust from the race and its surrounding area.
(1) Bobbin case (2) Cleaning brush (3) Race - Do not put oil on the bobbin case.
- Compressed can air is not recommended to be used.
-
Insert the bobbin case so that the and marks align.
(1) mark
(2) mark- Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may break or sewing performance may suffer. For a new bobbin case, contact your nearest Brother authorized service center.
- Make sure that you fit the bobbin case properly, otherwise the needle may break.
-
Attach the needle plate, and then tighten the screws.
Related FAQs
CE1010, CE6080T, CE6085T, ND50E, XS6070
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.