CM700
![]() |
FAQ et Diagnostic |
Date: 08/08/2016 ID: faqh00100481_000
How can I properly emboss without the material tearing?
If the material tore, check the following, and then try again.
Possible Causes | Solutions |
The embossing pressure is too strong. |
If the embossing pressure is too strong, the tool may press down on the material and tear it. Decrease the embossing pressure. |
Thin paper is being used as the material to be embossed. | Embossing is created by pressing the tool against the material. Thin paper may tear. Use thick paper. |
The embossing speed is fast. | If the embossing speed is too fast, paper may tear. Decrease the speed, and then try again. |
Adjust the embossing pressure and inward offset in the settings screen for “Premium functions” or embossing screen.
![]() |
or | ![]() |
CM260, CM300, CM600, CM700, CM840, CM900
Pour toute assistance supplémentaire, contactez le service clientèle de Brother:
Commentaires sur le contenu
Merci d'indiquer vos commentaires ci-dessous. Ils nous aideront à améliorer notre support.
Étape 1: Comment qualifieriez-vous les informations figurant sur cette page?
Étape 2: Souhaitez-vous ajouter des commentaires?
Ce formulaire a pour seul but de nous faire part de vos commentaires.