Innov-is 700E
Veelgestelde vragen en probleemoplossing |
Innov-is 700E
Datum: 07/04/2009 Nummer: faqh00000006_000
Place a spool of thread on a spool pin.
- Firmly hold the thread with a spool cap so that the thread does not turn too much.
Spool cap Make sure you use the correct size spool cap for the thread. If the spool cap is smaller the thread, tension may be incorrect.
- If you dont have a spool cap larger than the size of the thread, there is a slit in the thread spool.
Slit(Notch) Install the spoll so that the slit faces the base of the spool pin.
- It is important that the thread is pulled out from the spool smoothly. Make sure there is space around the spool cap and the tip of the spool pin for thread to pass through.
If a spool of thread turns too much and thread tension becomes improper, place a felt under the spool of thread.
Felt Spool pin |
BC-2100/2300, BC-2500, CS10, CS120WT, CS70, CS-8060, DS-120, DS-140, FS100WT, FS-20, FS-40, FS60, FS60s, FS70WT, FS70WTs, Innov-is 10/10A, Innov-is 100, Innov-is 1200, Innov-is 1250, Innov-is 15, Innov-is 1500D/1500, Innov-is 150SE/ 150, Innov-is 20/20LE, Innov-is 200, Innov-is 2200, Innov-is 27SE, Innov-is 30, Innov-is 35, Innov-is 350SE, Innov-is 400, Innov-is 4000D/4000, Innov-is 50, Innov-is 5000, Innov-is 500D, Innov-is 55, Innov-is 550SE/ 550, Innov-is 55FE, Innov-is 600, Innov-is 700E, Innov-is 750E, Innov-is 900, Innov-is 950, Innov-is 955, Innov-is I, Innov-is Ie, KD40, KE20, LS-1217, LS-2125, NX-200, NX-2000, NX-400Q/400, NX-600, PE-180D, XL-5130/5232/5340, XL-5500, XL-5600
Heeft u meer hulp nodig, dan kunt u contact opnemen met de Brother-klantenservice.
Feedback
Dit formulier is alleen bedoeld voor feedback.