PR1050X
FAQs & Troubleshooting |
PR1050X
Date: 01/12/2016 ID: faqh00100563_000
How do I set the machine to trim the threads between the characters?
If the machine is set to trim the threads between the characters, the jump stitches between the characters are reduced and any other necessary procedures after embroidering are reduced. However, the embroidering time will increase if the threads are trimmed between each of the characters.
Specifying the thread trim settings to trim the jump stitches between the characters
Change the settings to trim the jump stitches between the characters in the pattern editting screen
Touch so that it changes to .
Each touch of the key turns the setting either on or off.
⇔ | ||
Threads are not trimmed. | Threads are trimmed. |
PR1050X
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.