Innov-is XP1
 |
FAQs & Troubleshooting |
Innov-is XP1
Date: 26/09/2018 ID: faqh00101106_000
Loops appear on the surface of the fabric when embroidering
-
The thread tension is incorrectly set.
Adjust the thread tension.
Refer to How do I adjust thread tension for embroidering?
-
Under some conditions, based on the type of fabric, stabilizer, or thread being used, there may be some looping in the upper thread.
In this case, attach the included embroidery needle plate cover to the needle plate.
Refer to Using the embroidery needle plate cover.
-
The combination of the bobbin case and bobbin thread is incorrect.
Change the bobbin case or bobbin thread so that the correct combination is used.
Related FAQs
Innov-is XE1, Innov-is XE2, Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.