FAQs & Troubleshooting

Close

Innov-is NV180D

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is NV180D

Not your product?

Date: 10/07/2018 ID: faqh00000629_005

How do I set the bobbin?

Install the bobbin wound with thread. You can begin sewing immediately without pulling up the bobbin thread by simply inserting the bobbin in the bobbin case and guiding the thread through the slit in the needle plate cover.

 

If the threads will be pulled to create gathers or the thread at the beginning of sewing will be finished, for example, when free motion quilting, first pull up the bobbin thread. For details, refer to “How do I pull up the bobbin thread?”.

  • Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect.
    img01
  • Before inserting or changing the bobbin, be sure to press img02 on the operation panel to lock all keys and buttons, otherwise injuries may occur if the “Start/Stop” button or any other button is pressed and the machine starts.

 

 

  1. Turn on the machine.



     
  2. Press img03 (Needle position button) once or twice to raise the needle.



     
  3. Press img04 .
    The screen changes, and all keys and operation buttons are locked (except img05 .
    img06

     
  4. Raise the presser foot lever.



     
  5. Slide the bobbin cover latch to the right and remove the bobbin cover.
    img07



     
  6. Insert the bobbin into the bobbin case so that the thread unwinds to the left.
    img08

     
  7. Lightly hold down the bobbin with your right hand (A), and then guide the end of the thread around the tab of the needle plate cover with your left hand (B).
    img09 (1) Tab

    Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect.



     
  8. While lightly holding down the bobbin with your right hand (A), guide the thread through the slit in the needle plate cover (B) and lightly pull it with your left hand (C).
    img10

    By guiding the thread around the tab of the needle plate cover, passing the thread as shown by 2 in this illustration, then lightly pulling the thread at 3, the thread will enter the tension spring of the bobbin case to apply the appropriate tension to the bobbin thread during sewing.




     
  9. While lightly holding down the bobbin with your right hand (A), continue guiding the thread through the slit with your left hand (B). Then, cut the thread with the cutter (C).
    img11

    Be sure to complete the bobbin threading correctly according to these instructions. If the thread is simply placed in the slit in the needle plate cover, the bobbin thread will not be correctly threaded, resulting in poor sewing performance or incorrect thread tension.



     
  10. Reattach the bobbin cover.
    Insert the tab of the bobbin cover into the notch of the needle plate cover (A), and then lightly press down on the right side (B).
    img12

    You can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread before starting to sew, pull up the thread according to the procedure in “How do I pull up the bobbin thread? ”.



     
  11. Press img13 to unlock all keys and buttons.
    img14

 

Related FAQs

Related Models

Innov-is M370, Innov-is M380D, Innov-is NV180, Innov-is NV180D

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.