FAQs & Troubleshooting

Close

DC200

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 24/10/2017 ID: faqh00000698_001

The mat is fed in at an angle and is not fed during cutting / drawing.

Possible Causes (or Results)

 

  • The mat’s adhesive strength has decreased, or the material is not secured.
  • The material extends from the adhesive area of the mat.
     

 

Solutions

 

  1. Press the “Pause/Stop” button to stop the operation.
     
  2. Follow the instructions on the screen, and press the “Feed” buttonimage to feed out the mat.
      image

    If the mat does not feed out, turn off the machine (A), remove the holder (B), and then manually feed out the mat (C).
    image

     
  3. After feeding out the mat, replace it with a new one or attach the material while keeping it within the adhesive area of the mat.

    image

Related FAQs

Related Models

DC200

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.