FAQs & Troubleshooting

Close

Model discontinued. This page is no longer updated.

PT-65

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 25/01/2021 ID: faqp00000128_000

The tape keeps jamming.

Check the following:

 

  • Do not press the tape cutter button until the tape has stopped feeding.

  • Make sure that the end of the tape is correctly fed under the tape guides.
    Image
    1. Tape guide
    2. End of tape

  • In some isolate cases the tape cassette is bound and will not advance the tape. It is recommended that the cassette be replaced.

 

How to replace the tape cassette:

 

  1. Remove the back cover by pressing in on the rough area at the top end of the machine and pulling off the back cover.

  2. Make sure that the end of the tape in the new cassette feeds under the tape guides.

  3. Insert the new tape cassette until it clicks into place.
    Image

    Check that the cassette fits properly around the two metal guides in the cassette compartment.
    Image
    1. Metal guides


  4. Attach the back cover by inserting the two hooks on the bottom end of the back cover into the slots on the bottom end of the machine, then pushing down firmly on the cover until it snaps into place.

  5. Feed the tape by holding down the [Code] key and pressing the [Feed] key, and then cut the tape by pressing in on the tape cutter button.

Related Models

PT-65

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.