FAQs & Troubleshooting

Close

TD-4750TNWB

FAQs & Troubleshooting

FAQs & Troubleshooting

TD-4750TNWB

Not your product?

Date: 01/12/2021 ID: faqp00100465_001

Printing the printer configuration (Self-test)

Print the printer configuration after you run Gap/Black Mark Sensor calibration. (To print the Self-test printouts, see the FAQ: "How to execute the printer configuration (Self-test) to debug".)

The self-test printout lists the printer's configuration and available memory, and can indicate if there is any dot damage on the heater component.

 

Self-test printout

System Information

1. Model name
2. Firmware version
3. Firmware checksum
4. Printer Serial number
5. Configuration file
6. System date
7. System time
8. Printed mileage (meter)
9. Cutting counter
10. Number of defective dots

Printing Setting 1. Print speed (inch/sec)
2. Print density
3. Label size (inch)
4. Gap distance (inch)
5. Gap/Black Mark Sensor sensitivity
6. Code page
7. Country code
Z Setting ZPL setting information
1. Print darkness
2. Print speed (inch/sec)
3. Label size
4. Control prefix
5. Format prefix
6. Delimiter prefix
7. Printer power up motion
8. Printer head close motion

ZPL is emulating for Zebra® language.

RS232 setting RS232 Serial Port configuration
BT Setting Bluetooth® configuration
RFID setting Country of RFID frequency band
Ethernet setting 1.Printer name
2.Mac Address
3.DHCP
4.IP Address
5.Subnet Mask
6.Gateway
7.RAW Port
WiFi setting Wi-Fi® configuration
Dram/Flash File 1. Numbers of downloaded files
   Total and available memory space
2. Print Head check pattern

Related Models

TD-4650TNWB, TD-4750TNWB

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.