Innov-is M370
 |
FAQs & Troubleshooting |
Innov-is M370
Date: 15/10/2020 ID: faqh00101099_001
The bobbin thread cannot be pulled up.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Bobbin is set incorrectly.
Reset the bobbin thread correctly.
Refer to How do I set the bobbin ?
-
Upper threading is incorrect.
Check the steps for threading the machine and rethread the machine correctly.
Refer to How do I thread the machine ?
Related FAQs
Innov-is A150, Innov-is A16, Innov-is A80, Innov-is F410, Innov-is F420, Innov-is M370, Innov-is M380D, Innov-is NQ3500D, Innov-is NS2750D, Innov-is NV1100, Innov-is NV1300, Innov-is NV180, Innov-is NV1800Q, Innov-is NV180D, Innov-is NV2600, Innov-is NV50S, TY600C
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.