Innov-is XE2
FAQs & Troubleshooting |
Innov-is XE2
Date: 29/07/2019 ID: faqh00101094_000
Bobbin thread breaks
-
Bobbin is set incorrectly.
Reset the bobbin thread correctly.
Refer to How do I set the bobbin?
-
Bobbin thread is incorrectly wound.
Use a correctly wound bobbin.
Refer to How do I wind the bobbin?
-
There are scratches on the bobbin or it doesn’t rotate properly.
Replace the bobbin.
Refer to How do I set the bobbin?
-
Thread is twisted.
Use scissors, etc. to cut the twisted thread and remove it from the race, etc.
-
A bobbin designed specifically for this machine is not being used.
Incorrect bobbins will not work properly.
Only use a bobbin designed specifically for this machine.
Refer to How do I set the bobbin?
Related FAQs
Innov-is XE1, Innov-is XE2, Innov-is XJ1, Innov-is XJ2, Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.