DC200
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_dc200eas.jpg)
DC200
Date: 24/10/2017 ID: faqh00000703_001
There are deep cuts completely through the mat.
Possible Causes (or Results)
Case 1 : The blade extension from the blade holder is too much.
Case 2 : The cutting pressure (“Cut Pressure”) is incorrect.
For details on the appropriate blade extension and cutting pressure, see Mat and Material Combinations.
Solutions
Case1
Remove the holder from the carriage, and then adjust the blade extension.
>> For details, see Adjusting the Blade Extension.
![]() |
(1) Turn to the left to decrease the blade extension.
|
Case2
Adjust the setting for “Cut Pressure” in the pattern preview window of DesignNCut Manager.
For the computer users using a Wireless LAN connection, click here.
For the computer users using a USB cable, click here.
For the mobile device users, click here.
or
Adjust the setting for “Cut Pressure” in the settings of DesignNCut Manager.
For details, see About DesignNCut Manager.
- If the cutting pressure is too high, the mat or blade tip may be damaged. Adjust it to an appropriate setting.
- Adjustments to the cutting pressure will affect the finished product. Use the same material that the pattern will be cut on to make the adjustments.
DC200
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.