DC200
FAQs & Troubleshooting |
DC200
Date: 24/10/2017 ID: faqh00000701_001
The machine stopped while an operation is being performed.
Possible Causes (or Results)
For safety, the machine stops operating if a button in the operation panel is pressed while cutting or drawing.
Solutions
Check that either of the following messages appear, and then press to return the carriage to its original position.
Insert the mat, and then try performing the operation again.
- When cutting
Cutting paused. Resume: [OK] Stop: [STOP]
- When drawing
Drawing paused. Resume: [OK] Stop: [STOP]
DC200
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.