5100D
FAQs & Troubleshooting |
5100D
Date: 24/11/2010 ID: faqh00000525_001
Retracting knife
To sew without cutting the fabric edge, you need to retract the knife as follows.
- Do not touch the knife.
- Move the knife lever only while the needle is at its lowest point.
- Be sure to unplug the power supply cord from the wall outlet before retracting the knife.
- Pull up the knife lever <A>, then pull it to the right.
- Bring down the knife.
- Retract the knife completely, then take your hand off from the lever.
4234D, 5100D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.