5100D
 |
FAQs & Troubleshooting |
5100D
Date: 20/04/2011 ID: faqh00000518_001
Threads break
-
Improper threading
Thread correctly.
-
Thread tangled
Check spool pin, thread holders, etc. and remove tangled thread.
-
Thread tension too tight
Adjust the thread tension.
-
Needles incorrectly installed
Install needles correctly.
-
Wrong needle used
Use correct needle
Schmetz 130/705H - suggested
-
The tip of the thread change assembly is not in the eye of the upper looper.
Put the tip of the thread change assembly in the eye of the upper looper.
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.