DCP-1616NW
FAQs & Troubleshooting |
DCP-1616NW
Date: 25/09/2014 ID: faq00003167_008
Load paper in the paper tray
Follow the steps below to load paper in the paper tray:
NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.
-
Open the front cover.
-
Adjust the paper guide.
-
Fan the paper.
-
Load paper with the printing surface face up in the paper tray.
-
Adjust the paper guides to fit the paper.
Make sure that your papers are loaded properly.
-
Open the top cover.
-
Lift the paper support flap.
-
Close the top cover.
After pulling the pull-arm (1) on the left side of the machine down, close the scanner cover using both hands.
-
Open the front cover.
-
Adjust the paper guide, and then install the A5 paper tray part you unpacked earlier.
-
Fan the paper.
-
Load paper with the printing surface face up in the paper tray.
-
Press and slide the paper guides to fit the paper.
-
Adjust the paper guide.
Make sure that your papers are loaded properly.
-
Open the top cover.
-
Lift the paper support flap.
-
Close the top cover.
After pulling the pull-arm (1) on the left side of the machine down, close the scanner cover using both hands.
Related FAQs
DCP-1610W, DCP-1615NW, DCP-1616NW, MFC-1910W, MFC-1911NW, MFC-1911W, MFC-1915W, MFC-1916NW
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.