ADS-4700W
FAQs & Troubleshooting |
ADS-4700W
Date: 27/06/2024 ID: faq00100833_001
The scanning speed is slow when scanning from my machine. (Windows)
To improve the scanning speed when scanning from your machine, check the following points:
Verify that your machine has been added to Brother iPrint&Scan.
To add your machine to Brother iPrint&Scan, follow the steps below.
-
Download and install the Full Driver & Software Package (if not already installed).
> Click here to download the Full Driver & Software Package in the Downloads section.
-
Download and install the Brother iPrint&Scan (if not already installed).
> Click here to download the Brother iPrint&Scan in the Downloads section.
- When the installation is complete, double-click the Brother iPrint&Scan icon.
- If your Brother machine is not listed, click the Select your Machine button, and then select your machine from the list of available machines.
- Click the Machine Scan Settings button to configure the scan settings.
- Place your document in the Automatic Document Feeder (ADF) or on the scanner glass.
- Press the Scan button on the machine.
Check the scan resolution.
The resolution may be too high for your document.
To change the resolution, follow the steps below.
- Double-click the Brother iPrint&Scan icon.
- Click the Machine Scan Settings button.
- Select lower resolution from the Resolution drop-down list.
- Click OK.
- Place your document in the Automatic Document Feeder (ADF) or on the scanner glass.
- Press the Scan button on the machine.
Check the USB cable you are using.
Make sure you use a USB 3.0 cable.
ADS-1200, ADS-1300, ADS-1350W, ADS-1700W, ADS-1800W, ADS-3000N, ADS-3100, ADS-3300W, ADS-3600W, ADS-4300N, ADS-4700W, ADS-4900W, DS-640, DS-740D, DS-940DW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.