FAQs & Troubleshooting

Close

RJ-2035B

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 29/10/2020 ID: faqp00100466_002

How to calibrate the Gap/Black Mark Sensor by directly operating the printer

  • The Gap Sensor(*) / Black Mark Sensor sensitivity should be calibrated when:
     - A new printer is purchased
     - Label media is changed
    (*) Product specifications vary by region. For more information, see the Specification Sheet from the [Manuals] section of this website.
     
  • Models not equipped with the Black Mark Sensor cannot be used with Die Cut Labels.

To calibrate the Gap/Black Mark Sensor:
 

  1. Turn off the printer.
  2. Press and hold the Feed/Pause Button (  ) and then turn on the printer.
  3. Release the Feed/Pause button (  ) when the printer's Status LED changes to (  ) and starts blinking.


    The LEDs will change as follows:
    (Orange)
    (5 times)    -> Release the Feed/Pause button (  ) to enter calibration mode.
    (5 times)
    (5 times)
    (Green (lit))

Related Models

RJ-2035B, RJ-3035B

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.