PT-E800T
FAQs & Troubleshooting |
PT-E800T
Date: 09/01/2024 ID: faqp00100267_000
How to insert a tube
-
Press the cover open button to open the top cover.
-
Pull the tube release lever up.
-
Pass the tube as shown in the illustration so that the end of the tube reaches the “” mark on the printer, and then push the tube release lever down.
-
Close the top cover.
- When using the printer, position it so direct sunlight does not enter the printer through the tube exit slot.
- For inserting a ribbon cassette, see “How to insert a ribbon cassette”.
-
You can use the tube half-cut adjuster to adjust the depth of half cuts to one of three settings.
For the location of the tube half-cut adjuster, see “The tube is not cut completely.”. - If the tube is jammed or not cut completely, use the (Feed and Cut) button to manually cut the tube completely. Press and hold the button for 2 to 10 seconds until the (Power) indicator changes from being lit in green to flashing in green, and then release it. The tube will be cut when the button is released.
Movie: How to print on a Tube
*The video clip is being streamed from YouTube.
Related FAQs
PT-E800T, PT-E850TKW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.