Innov-is A16
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inova16eas.jpg)
Innov-is A16
Date: 25/11/2019 ID: faqh00101472_001
List of Error Messages
If you press the stitch selection key or do the operation correctly while the error message is displayed, the message disappears.
When erroneous operations are performed messages and advice on operation will be displayed on the LCD. Follow what is displayed. The error message will disappear if an operation button is pressed or the correct operation is performed while the error message is displayed.
Error Messages |
Probable Cause & Solution |
|
---|---|---|
|
E1 |
Cause This message is displayed when a button, such as the “Start/Stop” button, is pressed (The foot controller was depressed if it is connected.) while the presser foot was raised.
Solution Lower the presser foot lever before continuing the operation. |
|
E2 |
Cause This message is displayed when the buttonhole lever is down, a stitch other than a buttonhole is selected, presser foot is lowered and a button, such as the “Start/Stop” button, is pressed (The foot controller was depressed if it is connected.).
Solution Raise the buttonhole lever before continuing the operation. |
|
E3 |
Cause This message is displayed when the buttonhole lever is up, a buttonhole stitch is selected, presser foot is lowered and a button, such as the “Start/Stop” button, is pressed (The foot controller was depressed if it is connected.).
Solution Lower the buttonhole lever before continuing the operation. |
|
E4 |
Cause This message is displayed when a button, such as the Reverse stitch button, is pressed while the bobbin winder shaft is moved to the right.
Solution Move the bobbin winder shaft to the left before continuing the operation. |
|
E5 |
Cause This message is displayed when the “Start/Stop” button is pressed while the foot controller is connected.
Solution Disconnect the foot controller, and then press the “Start/Stop” button. Otherwise, operate the machine by using the foot controller. |
|
E6 |
Cause The motor locked up because the thread became tangled.
Solution Click the following link to see the details of solutions. |
|
E9 |
Cause This message is displayed when the needle plate cover is removed while the machine is still turned on.
Solution Turn off the machine, and then attach the needle plate cover before continuing the operation. |
F* |
Cause If error message “F*” appears in the LCD while the machine is being used, the machine may be malfunctioning. (“*” will be replaced with a number.)
Solution Contact your nearest Brother authorized service center. |
Content Feedback
Please note this form is used for feedback only.