CM700
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_cm700eas.jpg)
CM700
Date: 28/11/2013 ID: faqh00000691_000
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : The mat was inserted into the feed slot at an angle.
Case2 : The corners of the mat are deformed (bent).
Solutions
----- Case1 -----
Press the “Feed” button to feed out the mat, and then re-insert it straight in.
----- Case2 -----
Replace the mat with a new one.
Related FAQs
CM110, CM300, CM350, CM550DX/ CM550, CM700, CM900
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.