Innov-is A16
FAQs & Troubleshooting |
Innov-is A16
Date: 02/11/2020 ID: faqh00000061_002
"E3" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
- The Start/Stop button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
- The Reverse/Reinforcement stitch button is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
- The foot controller is pressed while the buttonhole or bar tack stitch is selected and the buttonhole lever is raised.
Solution
Lower the buttonhole lever before continuing the operation.
Innov-is A16
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.