FAQs & Troubleshooting

Close

CS-8120

FAQs & Troubleshooting

FAQs & Troubleshooting

CS-8120

Not your product?

Date: 25/02/2009 ID: faqh00000012_000

The thread is looping when I try to wind a bobbin.

Looping while winding the bobbin could be caused by several reasons.

 


  • The thread may not be threaded through the thread guide properly.
    Rethread guide following the diagram on the machine.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    1 Thread guide for bobbin winding
    2 Two slits
  • The bobbin winder cover may not be pushed all the way open. When opening the bobbin winder cover, make sure it is push open as far as it will go.
    When opening the bobbin winder cover, make sure it is push open as far as it will go.
  • The thread could be winding off to quickly. When using threads such as transparent nylon thread or metallic threads, place the spool net over the spool before placing the spool of thread onto the spool pin.
    Place the spool net over the spool before placing the spool of thread onto the spool pin. 1 Spool net
    2 Spool
    3 Spool pin
    4 Spool cap

Related Models

CS-8060, CS-8120

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit