JC14

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I change the needle ?

Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated.
Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.

image (1) Flat side

(2) Needle type marking

If the distance between the needle and the flat surface is not even, the needle is bent.

Do not use a bent needle.

image

(1) Flat surface

  • Always turn off the machine before you change the needle. Otherwise, injuries may occur if the foot controller is accidentally pressed and the machine starts sewing.
  • Only use sewing machine needles for home use. Other needles may bend or break and cause injury.
  • Never sew with a bent needle. A bent needle will easily break and cause injury.
  1. Turn off the machine.
     

     

  2. Raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up.
    image (1) Mark on the handwheel

     

  3. Lower the presser foot lever.
    image (1) Presser foot lever

    Before replacing the needle, cover the hole in the needle plate with fabric or paper to prevent the needle from falling into the machine.

     

  4. Hold the needle with your left hand, and then use a screwdriver to turn the needle clamp screw toward you (counterclockwise) to remove the needle.
    image (1) Use a screwdriver
    Do not use excessive force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged.
    image

     

  5. With the flat side of the needle toward the back of the machine, insert the needle until it touches the needle stopper. Next, tighten the needle clamp using a screwdriver.
    image (1) Use a screwdriver
    (2) Needle stopper
    (3) Needle

     

Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the screwdriver, otherwise the needle may break or damage may result.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

J17s, JA001, JA1400, JA1450NT, JA1710, JA20, JC14, JK17B, JV1400, NB1700Plus, SL170, TR14A, TY200A, X14s

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.