QL-550

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I install/change the label roll?

 To install a new label roll

 To remove the label roll

 

 

To install a new label roll:
 

  1. Press the ON/OFF button to turn the printer off.

  2. Hold the DK Roll compartment cover at the sides near the front of the printer and firmly lift it up to open.
    Open cover

  3. Pull up the roll release lever (1) and remove the protection sheet (2) of printing unit. (QL-500/550 only)
    Remove the protection sheet

  4. Insert the spool of the DK Roll along the spool guides of the printer.

    Make sure that the spool arms (3) are inserted firmly in the spool guides (4) on the left and right sides.
    Insert the spool

  5. Lift up the roll release lever (5) and then thread the end of the DK Roll into the printing unit (6) immediately before the cutter (7).
    Insert label

    If you are unable to thread the end of the DK Roll into the printing unit, thread it as far as possible, lower the roll release lever and close the cover. Then press the FEED button to set the roll.

  6. Lower the label lever and then close the DK Roll compartment cover.
    Close cover

 

To remove the label roll:

 

  1. Press the ON/OFF button to turn the printer off.

  2. Hold the DK Roll compartment cover at the sides near the front of the printer and firmly lift it up to open.
    Open cover

  3. Lift up the label lever.
    Hold the label roll by the spool arms and pull the inserted DK Roll up.
    Remove Roll

  4. Lower the label lever and then close the DK Roll compartment cover.
    Close cover

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

QL-500, QL-550

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.