"Cannot operate when there are too many patterns."

message appearing on the LCD. What does it mean?

The message appears under the following conditions.

 Cause Solution 
 There are 301 or more patterns being cut in the “Direct Cut” mode.  Reduce the number of patterns being used.
 There are 301 or more patterns being saved as cutting data in the “Scan to Cut Data” mode.
 There are too many cutting lines to be created after large number of small patterns are scanned.  Scan images again after reducing the number of patterns arranged in the original.
 There are too many light tone patterns to be converted to two-tone (black and white) patterns while the image detection level is being adjusted.

Perform the necessary operation according to the instructions or the solution described.
If the problem persists, contact the retailer who sold you this machine or the nearest authorized service center.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CM110, CM550DX/ CM550

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.