CM350H
FAQs & Troubleshooting |
9 Results
Sort by
- 107/10/2017Not all of the material to be cut is cut. Some areas remain uncut.
- 207/10/2017The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- 307/10/2017The mat is fed in at an angle and is not fed during cutting / drawing.
- 407/10/2017The mat or the material catches on a feed roller during cutting/drawing.
- 506/09/2017I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- 601/16/2017What should I do if the entire pattern is not cut?
- 701/16/2017What should I do if part of the material is not cut?
- 808/08/2016What should I do if the scanned and cut positions are misaligned?
- 908/19/2015There are deep cuts completely through the mat.