NX-2000
![]() |
FAQs & Troubleshooting |
20 Results
Sort by
- 103/08/2018"The safety device has been activated. Is the thread tangled? Is the needle bent?" message appears on the LCD. What does it mean?
- 229/07/2016"A malfunction occurred. Turn the machine off, then on again." message appears on the LCD. What does it mean?
- 302/04/2008"Turn off the power and replace the needle plate." appears on the LCD.
- 402/04/2008"The needle is down. Press the needle position button to raise the needle." appears on the LCD.
- 518/01/2008"Lower the presser foot lever." appears on the LCD.
- 606/11/2007"When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD.
- 706/11/2007"The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller." appears on the LCD.
- 830/06/2006"Saving the upgrade file. Do not turn MAIN power to OFF." appears on the LCD.
- 930/06/2006"OK to save the current setting?" appears on the LCD.
- 1030/06/2006"In twin needle mode, the needle thread lever cannot be used." appears on the LCD.
- 1130/06/2006"Connected to PC. Do not disconnect the USB cable." appears on the LCD.
- 1230/06/2006"OK to automatically lower the presser foot?" appears on the LCD.
- 1330/06/2006"This function can not be used while the machine is in twin needle mode. Cancel twin needle mode and choose the function again." appears on the LCD.
- 1430/06/2006"Not enough available memory to save the pattern. Delete another pattern?" appears on the LCD.
- 1530/06/2006"The bobbin thread is almost empty." appears on the LCD.
- 1630/06/2006"The bobbin winder safety device has activated. Is the thread tangled?" appears on the LCD.
- 1728/06/2006"Lower the buttonhole lever." appears on the LCD.
- 1828/06/2006"Raise the buttonhole lever." appears on the LCD.
- 1928/06/2006"Check and rethread the upper thread." appears on the LCD.
- 2028/06/2006"Use the presser foot lifter button to lower the presser foot." appears on the LCD.