DC100
 |
FAQs & Troubleshooting |
14 Results
Sort by
- 126/12/2018If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- 226/10/2017The mat or the material catches on a feed roller during cutting/drawing.
- 324/10/2017The material to be cut/drawn peels off during cutting/drawing.
- 424/10/2017The material to be cut/drawn cannot be attached to the mat.
- 524/10/2017Mat and Material Combinations
- 624/10/2017There are deep cuts completely through the mat.
- 724/10/2017The mat is fed in at an angle and is not fed during cutting / drawing.
- 824/10/2017The mat or the material catches on a feed roller when the mat is being inserted.
- 924/10/2017The mat cannot be fed.
- 1024/10/2017When the mat is inserted, the attached material peels off.
- 1124/10/2017The mat cannot be fed out.
- 1224/10/2017The mat is fed in at an angle.
- 1324/10/2017The mat cannot be recognized.
- 1424/10/2017The mat cannot be inserted.
