SDX950
FAQs & Troubleshooting |
13 Results
Sort by
- 106/06/2024The Material to be Cut is Not Cleanly Cut with the Roll Feeder.
- 203/02/2020How to Activate an Accessory Kit* (Rhinestone, Emboss Kit, etc.) for the Cutting Machine.
- 311/03/2019Retrieving Roll Feeder Data On the Machine and Cutting
- 411/03/2019How should I make a pattern to be cut with the roll feeder?
- 511/03/2019Cutting data is not displayed in Roll Feeder.
- 621/12/2018How Do I Perform Trial Cutting for Roll Feeder? (Test Cut)
- 721/12/2018What Should I Do If the Trimmer Blade Has Been Removed from the Trimmer?
- 821/12/2018What Should I Do If the Material is not being Cleanly Cut by the Trimmer Blade?
- 917/12/2018How to Install the Roll Feeder
- 1014/12/2018Care and Maintenance (Cleaning the Trimmer Blade)
- 1114/12/2018Using the trimmer blade to trim the end of the material
- 1214/12/2018The rolled material did not feed correctly.
- 1303/10/2018Adjusting the Position of the Feed Roller