Innov-is BP3600
FAQs & Troubleshooting |
How do I thread my machine ?
(1) Upper thread shutter |
If you try to thread the needle automatically without raising the needle, the needle may not be thread correctly and the needle threader may be damaged.
When using thread that winds off quickly, such as metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin. If the spool net is too long, fold it to fit the size of the spool.
When threading the spool with the spool net on, make sure that about 5 cm (2 inches) of thread is pulled out. It may be necessary to adjust the thread tension when using the spool net.
(1) Thread guide plate
Look in the upper groove area to check if the thread catches on the thread take-up lever visible inside the upper groove area.
(1) Needle bar thread guide
(2) Tab
(1) Notch in thread guide (2) Thread guide disk |
(1) Thread cutter |
When using thread that quickly winds off the spool, it may be difficult to thread the needle if the thread is cut.
Therefore, instead of using the thread cutter, pull out about 8 cm (3 inches) of thread after passing it through the thread guide disks (marked 7).
(1) About 8 cm (3 inches) or more |
(1) About 10 cm (4 inches) |