2340CV
![]() |
FAQs & Troubleshooting |
Needle threading
Always be sure to turn off the power before carrying out the following operation.
Follow the procedure described below to thread the needles.
When needle threading, always thread in this order:
Left needle, center needle and then right needle.
Run the thread in the sequence illustrated, following the yellow color and the numbers next to each threading point. (1) - (9)
(A) Pass the left needle thread through the left side of the branching plate.
(D) Branching plate
(E) Pull about 6 cm (about 2-1/2 inches) of thread through the eye of the needle.
(F) Tension disk
(G) Thread tension release button
(9) Front to back
Run the thread in the sequence illustrated, following the pink color and the numbers next to each threading point. (1) - (9)
(B) Pass the center needle thread through the left side of the branching plate.
(D) Branching plate
(E) Pull about 6 cm (about 2-1/2 inches) of thread through the eye of the needle.
(F) Tension disk
(G) Thread tension release button
(9) Front to back
Run the thread in the sequence illustrated, following the green color and the numbers next to each threading point. (1) - (9)
(C) Pass the right needle thread through the right side of the branching plate.
(D) Branching plate
(E) Pull about 6 cm (about 2-1/2 inches) of thread through the eye of the needle.
(F) Tension disk
(G) Thread tension release button
(9) Front to back
Pull about 6 cm (about 2-1/2 inches) of thread through the eye of the needle.