Innov-is NV800E
![]() |
FAQs & Troubleshooting |
How do I thread the machine (Threading the upper thread)?
![]() |
(1) Presser foot lever |
The upper thread shutter opens so the machine can be threaded.
If the presser foot is not raised, the machine cannot be threaded.
![]() |
(1) Needle position button |
The needle is correctly raised when the mark on the handwheel is at the top, as shown below. Check the handwheel and, if this mark is not at this position, press (Needle position button) until it is.
![]() |
(1) Mark on handwheel |
![]() |
(1) Spool pin
(2) Spool cap |
Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom.
![]() |
(1) Thread guide cover |
![]() |
![]() |
The screen changes, and all keys and operation buttons are locked (except ).
The thread can easily be slid behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand, as shown.
![]() |
![]() |
![]() |
(1) Presser foot lever |
![]() |
(1) Notch of the threader thread guide
(2) Threader thread guide disk |
![]() |
(1) Cutter |
![]() |
(1) 80 mm (approx. 3 inches) or more |
![]() |
(1) Presser foot lever |
![]() |
(1) Hook
(2) Needle threader lever |
Turn handwheel counterclockwise until the needle is at its highest position.
![]() |
(1) Mark on handwheel |
When pulling out the thread, do not pull it with extreme force, otherwise the needle may break or bend.
![]() |
(1) 5 cm (approx. 2 inches) |