ES-2000/2000T
FAQs & Troubleshooting |
How do I wind the bobbin?
(1) Pre-tension disk (2) Bobbin winder shaft (3) Bobbin |
(1) This model (2) Other models
1. | Pull up the spool pin as far as possible, and then put a spool of thread on this pin. |
|
|
2. | Pass the thread around the pre-tension disk. |
Make sure that the thread passes under the pre- tension disk. |
|
|
|
(1) Pre-tension disk (A) Pulling it in as far as possible
|
|
If the spool of thread is not in the right place, the thread may tangle on the spool pin. |
|
3. | Pass the end of the thread through the hole on the bobbin from the inside of the bobbin. |
|
|
4. | Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right. |
|
|
5. | Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the groove of the bobbin. |
(1) Spring on the shaft (2) Groove of the bobbin
|
|
6. | Turn on the sewing machine. |
|
|
7. |
While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times. Then stop the machine. |
|
|
Connect the foot controller before turning on the machine. |
|
8. | Trim the excess thread above the bobbin. |
|
|
Make sure you follow the instructions carefully. |
|
10. | Press the foot controller to start. |
|
|
11. | When the bobbin seems full and begins spinning slowly, take your foot off the foot controller. |
|
|
12. | Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin. |
|
Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle.
(1) Wound evenly (2) Wound poorly