HL-3075CW
FAQs & Troubleshooting |
IMPORTANT:
If you have previously configured the wireless settings of the machine, you must reset the network LAN settings before you can configure the wireless settings again. Click here to see the details of how to reset the machine back to the factory settings.
If you have a WLAN access point/router supporting WPS (Wi-Fi Protected Setup) or AOSS™ (AirStation One-Touch Secure System), you can easily connect your Brother machine to your wireless network as below.
To use WPS or AOSS™, your WLAN access point/router must support WPS or AOSS™. Confirm your WLAN access point/router has the WPS or AOSS™ symbol as shown below. For more details, refer to the instructions provided with your access point/router.
The range may differ depending on your environment. Refer to the instructions provided with your access point/router.
The length holding down the button may differ depending on the WLAN access point/router. For the information on how to confirm if the WLAN access point/router is ready for use, refer to the instructions provided with your access point/router.
LCD shows | Connection status | Action |
---|---|---|
Setting WLAN | Searching or accessing the access point, and downloading settings from the access point. | - |
Connecting WPS Connecting AOSS |
Connecting to the access point. | - |
Connected | Connection succeeded. | If you connect the Brother machine to a wireless network for the first time, go to STEP II: Installing the driver for network. |
Connection Error | A session overlap was detected. | Check that only one router or access point has the Wi-Fi Protected Setup mode or AOSS™ mode enabled and try starting from STEP 2 again. |
No Access Point | The access point detection failed. | 1. Move the machine closer to your access point/router and try starting from STEP 2 again. 2. If the same message continues, reset the machine back to the factory settings and try again. Click here to see the details of how to reset the machine back to the factory settings. |
Connection Fail | Connection failed. |
1. Try starting from STEP 2 again. |
Please continue to the following steps to install the printer driver for network connection. Even if you have printed with USB connection, you need to install the printer driver for network connection.
NOTE: The screens may differ depending on operating system being used and your Brother machine.
If there are any programs running, close them.
For Windows users:
For Macintosh users:
If you do not have the CD-ROM, please go to Downloads section of this website and download the printer driver. The installation instructions are available on the download page.
NOTE: If the installation screen does not appear automatically, click here to see how to open the installan.
When the User Account Control screen appears, click Allow or Yes.