PE550D
FAQs & Troubleshooting |
How do I wind the bobbin?
* Made of plastic
(1) This model (2) Other models (3) 11.5 mm (approx. 7/16 inch) |
(1) Notch (2) Bobbin winder shaft spring |
(1) The thread unwinds to the front from the bottom. |
(1) Spool cap (small) (2) Spool (cross-wound thread) (3) Space |
(1) Spool net
(2) Spool (3) Spool cap (4) Spool pin |
(1) Thread spool insert (mini king thread spool) (2) 12 mm (1/2 inch) (3) 75 mm (3 inches) |
(1) Thread guide (2) Thread guide cover |
(1) Bobbin winding thread guide (2) Pretension disk (3) Pull it in as far as possible |
Make sure that the thread is passed under the pretension disk.
(1) Guide slit in bobbin winder seat (with built-in cutter) |
Be sure to wind the thread clockwise around the bobbin, otherwise the thread will become wrapped around the bobbin winder shaft.
Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the guide slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out.