Innov-is VE2200
FAQs & Troubleshooting |
The following is the procedure specifying the embroidery pattern location by selecting the pattern edge with the sensor pen.
For example, this method is useful when you want to place the name along a line on a fabric.
This function can be performed in either "Embroidery" or "Embroidery Edit" mode, but the procedure described below is performed in "Embroidery" mode.
Normally, you will take the easy way to select the pattern center for specifying the embroidery location.
If you want to specify the embroidery location at the pattern center, refer to the procedure specifying the location by selecting the pattern center with the sensor pen. >>> Click here
The following procedure describes how to place the character pattern along the line specifying the left bottom corner of the character pattern with the sensor pen.
(1) Character pattern
(2) Line which you want to place the pattern along
(3) Left bottom corner of the character pattern
When you use the extra large embroidery frame, select the desired area and press OK key.
* The message in the screen may vary depending on the embroidery pattern.
* The following screen appears.
(1) Left bottom corner of the pattern
* Specified point number turns into red.
(black) >>> (red)
If you touch the invalid sewing area with the sensor pen, the following message appears.
Press CLOSE key and touch the point again within the sewing area with the sensor pen.
(2) The point on the line which you want to place the pattern along
* Specified point number turns into red.
(black) >>> (red)
If you don't need to adjust the positions, press OK key and continue to step 20.
If the specified pattern position extends out of the pattern area, the following message appears instead of above message.
Press CLOSE key and specify the pattern position again within the embroidery field.