PT-D450
FAQs & Troubleshooting |
How do I eliminate the margin from the start or end of my label when printing?
Due to the construction of the tape mechanism, the approximately 25 mm (one inch) piece of tape that is produced prior to every label cannot be eliminated. However, when you print more than one label continuously, the subsequent labels can be printed without the excess tape.
The following methods are useful for reducing tape use:
This eliminates the margin at the end of the tape after printing as shown below:
|
Large Margin
|
|
Small Margin |
This eliminates the margin of the subsequent labels as shown below:
After the last label is printed, the printer stops in the middle of printing area.
After [OK to Feed?] is displayed, press the [OK] key ( ) or [Enter] key ( / ) to feed the tape.
Then to cut off the label, press the tape cutter lever on the upper left corner of the printer.
An example of the labels: