Innov-is VM6200D
FAQs & Troubleshooting |
The following is the procedure specifying the embroidery pattern location by selecting the pattern center with the sensor pen.
This function can be performed in either "Embroidery" or "Embroidery Edit" mode, but the procedure described below is performed in "Embroidery" mode.
Normally, you will take the easy way to select the pattern center for specifying the embroidery location.
However, you have the option of taking the way to select the pattern edge for that.
It is useful in case of placing the name along a line.
If you want to specify the embroidery location at the pattern edge, refer to the procedure specifying the location by selecting the pattern edge with the sensor pen. >>> Click here
When you use the extra large embroidery frame, select the desired area and press OK key.
* The message in the screen may vary depending on the embroidery pattern.
* The following screen appears.
(A) Center line of the pattern
(B) Pattern position
(1) Center point of the pattern
* Specified point number turns into red.
(black) >>> (red)
If you touch the invalid area of sewing with the sensor pen, the following message appears.
Press CLOSE key and touch the point again within the sewing area with the sensor pen.
(A) Center line of the pattern
(B) Pattern position
(2) Point on the center line of the pattern to upper direction
* Specified point number turns into red.
(black) >>> (red)
If you don't need to adjust the positions, press OK key and continue to step 19.
If the specified pattern position extends out of the pattern area, the following message appears instead of above message.
Press CLOSE key and specify the pattern position again within the embroidery field.
When using the sensor pen to specify the embroidering position, it may not be possible to exactly specify the desired location.
In this case, move the embroidery frame to align the center of the pattern with the location indicated by the LED pointer.