MFC-9700
![]() |
FAQs & Troubleshooting |
The FAX/MFC has three receive modes to choose from. Using the terms outlined below, choose the receive mode that best suits your needs.
FAX ONLY mode is best used when you have your FAX/MFC on a dedicated fax line. In this receive mode, the FAX/MFC automatically answers every call with receiving tones as if it were an incoming fax. If you select FAX ONLY mode, you cannot receive incoming voice calls on the telephone line your FAX/MFC is connected to, though you can make outgoing calls on the line.
In MANUAL mode, you control the telephone line and must answer every call yourself. If you answer the line and hear fax tones, wait until your FAX/MFC begins to respond with its own receiving tones, then hang up the phone. The FAX/MFC will receive the fax and print it out. You can receive incoming voice calls when using this receive mode just as you would if the FAX/MFC was not present on the line. This mode is preferable if you do not receive many faxes, if the FAX/MFC will be on the same telephone line as a computer modem, or if you are using Distinctive Ring.
EXT.TEL/TAD mode is optimal if you receive very few faxes or if you have an external answering machine on your phone line.
If an external telephone is connected to the EXT. jack, you control the phone line and must answer every call yourself.
If an external TAD (telephone answering device) is connected to the EXT. jack, the TAD automatically answers every call. Voice messages are stored in the external TAD. Fax messages are printed. When using this mode with an external TAD, these guidelines MUST be followed:
If you have Voice Mail on the phone line you on which will install your new MFC on, there is a strong possibility that Voice Mail and the MFC will conflict with each other while receiving incoming calls. However, this Distinctive Ring feature allows the use of more than one number on your line, so both Voice Mail and the MFC can coexist peacefully.