FAQs & Troubleshooting

When you sew gathers or finish up the threads at the beginning of sewing, draw up the bobbin thread.

1. Refer to "How do I thread my machine?" to thread the machine with the upper thread and thread the needle.


2. If the power of the machine is on, turn it off.
   
    
3. Raise the presser foot lever.
   
    
4. Open the bobbin cover.
   
    
5. Place the bobbin in the bobbin case so that the thread unwinds to the left.

   (1) Bobbin case

6. Hold the end of the thread, push the bobbin down with your finger, and then pass the thread along the slit in the direction of the arrow as shown, and leave it there without cutting it.
   
7. Turn on the machine.
   
8. Lightly hold the end of the upper thread.

   (1) Upper thread

9. While holding the end of the upper thread, press   (Needle position button) twice to lower and raise the needle to draw up the bobbin thread.
   
10. Pull on the upper thread to draw up the bobbin thread.
    Next, pull out about 10 cm (4 inches) of both threads toward the back under the presser foot.
    

    (1) Bobbin thread

    (2) Upper thread

    (3) Pull out about 10 cm (4 inches)

     

11. Reattach the bobbin cover.