RJ-3230B
FAQs & Troubleshooting |
Configure IEEE 802.1x Authentication for a Wired or Wireless Network Using Web Based Management (Web Browser)
Start your web browser.
If you are using a Domain Name System or enable a NetBIOS name, you can type another name, such as "SharedPrinter" instead of the IP address.
For example:
https://SharedPrinter
If you enable a NetBIOS name, you can also use the node name.
For example:
https://[node name]
The NetBIOS name can be found in the Network Configuration Report.
The default password to manage this machine’s settings is located on the back of the machine and marked "Pwd".
Start from , if the navigation menu is not shown on the left side of the screen.
Select one of the following verification methods from the Server Certificate Verification drop-down list:
Option | Description |
---|---|
No Verification | The server certificate can always be trusted. The verification is not performed. |
CA Cert. | The verification method to check the CA reliability of the server certificate, using the CA certificate issued by the CA that signed the server certificate. |
CA Cert. + ServerID | The verification method to check the common name *1 value of the server certificate, in addition to the CA reliability of the server certificate. |
*1 The common name verification compares the common name of the server certificate to the character string configured for the Server ID. Before you use this method, contact your system administrator about the server certificate's common name and then configure Server ID.
For wired networks: After configuring, connect your machine to the IEEE 802.1x supported network. After a few minutes, print the Network Configuration Report to check the <Wired IEEE 802.1x> status.
Option | Description |
---|---|
Success | The wired IEEE 802.1x function is enabled and the authentication was successful. |
Failed | The wired IEEE 802.1x function is enabled; however, the authentication failed. |
Off | The wired IEEE 802.1x function is not available. |