Innov-is NV1300
Часто задаваемые вопросы и устранение неполадок |
How do I wind the bobbin?
(1) This model (2) Other models (3) 11.5 mm (approx. 7/16 inch) |
When the foot controller is connected, bobbin winding can be started and stopped with the foot controller.
(1) Notch (2) Bobbin winder shaft spring |
Slide the bobbin winder in the direction of the arrow until it snaps into place.
(1) Spool pin (2) Spool cap |
(1) Spool cap (small) (2) Spool (cross-wound thread) (3) Space |
(1) Spool net (2) Spool (3) Spool cap (4) Spool pin |
(1) Thread spool insert (mini king thread spool) (2) 12 mm (1/2 inch) (3) 75 mm (3 inches) |
(1) Thread guide cover |
(1) Thread guide plate |
(1) Thread guide (2) Pretension disk (3) Pull it in as far as possible |
Make sure that the thread passes under the pretension disk.
(1) Guide slit in bobbin winder seat (with built-in cutter) |
Be sure to cut the thread as described.
If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin and the needle may bend or break when the bobbin thread starts to run out.
(1) Speed controller |
(1) "Start/Stop" button |