To set the tape margins, follow the steps below.
-
Press the [Menu] key (
).
-
Press the cursor key (
) to select [Margin], and then press the [OK] key (
).
-
Press the cursor key (
) to select [Full/Half/Narrow/Chain Print], and then press the [OK] key (
).
[Full / Half / Narrow]
For leaving equal margins on both sides of the text.
The margin lengths are as follows:
[Chain Print]
For printing several ribbons/tapes with minimum margins.
-
Enter text.
-
Press the [Print] key (
). [Copies:] appears.
-
Press the cursor key (
) or number keys to select the number of copies.
-
Press the [OK] key (
). Printing starts, and then the message "Feed OK?" appears.
-
Press the [Esc] key (
) to enter more text.
-
Clear the text, enter the text for the next ribbon/tape, and then press the [Print] key (
).
-
When the message "Feed OK?" appears after the last ribbon/tape is printed, press the [OK] key (
).
-
After the tape is fed, press the cutter lever to cut off the chain of ribbons/tapes.
-
When you set [Chain Print], feed the ribbon/tape before using the cutter, otherwise a part of the text may be cut off.
-
When you set [Half] or [Narrow], the displayed ribbon/tape length is the length from the printed dots (:) to the end of the label. Cut along the printed dots (:) with scissors.
-
To print more than one copy of a label with minimum margins, set the margin to [Narrow].
-
Do not pull the tape because this may damage the tape cassette.