The Brother machine has separate consumables the toner cartridge and the drum unit. Verify you replace only the drum unit and not the toner cartridge. If you want to know their difference, refer to "What is the difference between the toner cartridge and the drum unit?"
Replace the drum following the steps below:
Replacing the drum unit
-
Make sure the machine is turned on.
-
Open the front cover.
![Open Front Cover Open Front Cover](/g/b/img/faqend/faq00000154_072/as_ot/en/1694641/OpenFrontCover.gif)
-
Remove the toner cartridge and drum unit assembly from the machine.
![Remove Toner Remove Toner](/g/b/img/faqend/faq00000154_072/as_ot/en/1694642/RemoveToner.gif)
-
Push down the green lock lever and take the toner cartridge out of the drum unit.
![Take Toner Out Take Toner Out](/g/b/img/faqend/faq00000154_072/as_ot/en/1694403/TakeOutToner.gif)
-
Unpack the new drum unit.
-
Put the toner cartridge firmly into the new drum unit until you hear it lock into place.
![Put Toner Put Toner](/g/b/img/faqend/faq00000154_072/as_ot/en/1694404/PutToner.gif)
Make sure you put the toner cartridge in correctly or it may separate from the drum unit.
-
Clean the corona wire inside the drum unit by gently sliding the green tab from left to right and right to left several times.
![Clean Corona Wire Clean Corona Wire](/g/b/img/faqend/faq00000154_072/as_ot/en/1694405/CleanCoronaWire.gif)
Be sure to return the tab to the Home position (
![TabHomePosition TabHomePosition](/g/b/img/faqend/faq00000154_072/as_ot/en/1003122/TabHomePosition.gif)
). The arrow on the tab must be aligned with the arrow on the drum unit. If it is not, printed pages may have a vertical stripe.
-
Install the toner cartridge and drum unit assembly back into the machine.
![Install Toner Install Toner](/g/b/img/faqend/faq00000154_072/as_ot/en/1694643/InstallToner.gif)
-
Close the front cover of the machine.
Reset the drum counter
When you replace the drum unit with a new one, you must reset the drum counter by completing the following steps:
-
Make sure the machine is turned on.
-
Press
(Settings) > All Settings > Machine Info. > Parts Life.
-
Press and hold Drum Life until the machine's display message changes.
-
Press Yes.
-
Press
(Home).