Print  |  Close

PE-DESIGN Ver.7

FAQs & Troubleshooting

FAQs & Troubleshooting

When I embroider a pattern with an outline and an inside region, there is a gap (where nothing is sewn) between the outline and the inside region. When the pattern is checked in the "Preview" screen, no gap appears between them. What can I do to finish the embroidery without this gap?


  • Make sure the fabric is set tightly into the hoop.

One Point Advice   Embroidery 

  • When embroidering on Stretch or Towel fabrics, try the following:
    <In the case of Stretch fabric>
    Attach an iron on stabilizer material to the bottom surface of fabric. 
    Follow the instructions provided with the stabilizer for proper adhesive.
    <In the case of Towel fabric>
    Place a stabilizer material under the fabric, and hoop the fabric and the stabilizer material together. 
    Also place a stabilizer material on the top surface of the fabric.

One Point Advice   Fabrics and stabilizer material for embroidery 

  • If the suggestions mentioned above don't improve the embroidery, please try to adjust.

    + "Pull Compensation".  Increase the "pull compensation" value if necessary in "Design Center" or "Layout & Editing".  

     + Refer to your Instruction Manual for detailed instructions on .

    + Pull Compensation or Applying Sewing Attributes to Lines and Regions.

     

    Ver.8 Ver.7 and Ver.6

      Ver.5



Print  |  Close