To install a new label roll:
-
Make sure that the printer is turned Off.
Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
![](/g/b/img/faqend/faqp00000397_005/id/en/2290720/01.gif)
-
Place the DK Roll into the Roll Spool Guide.
-
Make sure that the Roll Spool Arm (1) is inserted firmly in the Roll Spool Guide (2).
-
Make sure that the Stabilizer (3) slides into the notch of the printer.
![](/g/b/img/faqend/faqp00000397_005/id/en/2290721/02.gif)
-
Thread the DK Roll through the printer.
-
Align the edge of the DK Roll with the upright edge of the Label Output Slot.
-
Insert the first label into the slot inside the compartment.
-
Push the label through the Label Output Slot until the end reaches the mark, as shown.
![](/g/b/img/faqend/faqp00000397_005/id/en/2290722/03.gif)
-
Close the DK Roll Compartment Cover.
When you press the Power (
) Button to turn the printer On, the end of the DK Roll aligns automatically.
![](/g/b/img/faqend/faqp00000397_005/id/en/2290723/04.gif)
Do not leave any printed labels in the printer. Doing so will cause the labels to jam.
To remove a label roll:
-
Make sure that the printer is turned Off.
Hold the printer by the front, and firmly lift the DK Roll Compartment Cover to open it.
-
Hold the label roll by the spool arms and pull the inserted DK Roll up.
-
Close the DK Roll compartment cover.