Innov-is NV870SE
FAQs & Troubleshooting |
How do I wind the bobbin?
(1) This model (2) Other models (3) 11.5 mm (approx. 7/16 inch) |
When winding bobbin for embroidery be sure to use the recommended bobbin thread for this machine.
(1) Notch (2) Bobbin winder shaft spring |
Slide the bobbin winder in the direction of the arrow until it snaps into place.
(1) Spool pin (2) Spool cap |
(1) Spool cap (small) (2) Spool (cross-wound thread) (3) Space |
(1) Spool net (2) Spool (3) Spool cap (4) Spool pin |
(1) Thread spool insert (mini king thread spool) (2) 12 mm (1/2 inch) (3) 75 mm (3 inches) |
(1) Thread guide cover |
(1) Thread guide plate |
(1) Thread guide (2) Pretension disk (3) Pull it in as far as possible |
Make sure that the thread passes under the pretension disk.
(1) Guide slit in bobbin winder seat (with built-in cutter) |
Be sure to cut the thread as described.
If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin and the needle may bend or break when the bobbin thread starts to run out.
(1) "Start/Stop" button |