RJ-4040
FAQs & Troubleshooting |
How do I install/change the RD roll?
1 Adjuster lock |
- Make sure that the roll guide is properly positioned to prevent the RD Roll from moving sideways.
- If the RD Roll is not inserted correctly, the printer will not print on the correct side of the paper or label.
- When printing on die cut labels, set the roll guide so that there is 0.08 inches (2 mm) of space on both sides (0.16 inches (4 mm) total) of the scale.
Example: When using a 4-inch wide (101.6 mm) label, set the roll guide to a width of 4.16 inches (105.6 mm).
4 Guide lines |
Close the RD Roll compartment by pressing on the centre of the cover.
Press and hold the (Power) button to turn the printer on.
When using die cut label, press the (Feed) button after inserting the RD Roll. The printer will position the label to the correct starting position